SpecificationsKV:580KV/950KV/1050KVBase casing:Al 7075Stator:0.2mm Kawasaki silicon steelConfiguration:12N14PProp Adapter Shaft Thread:M5Shaft:Titanium Alloy hollow shaftNo.of Cells(Lipo):6SBolt Pattern:M3 (19X19mm)Bearings:Japanese NMB 12X6X4Rotor:N52H arc magnetsWeight:92.60g with 25cm SR wiresWire AWG:16# 25cm lengthBell cap:Al 7075

Hoboi Moke It hoppef Special Edition V4 32.5-12 drone electric motor Greater pulling force, more loads. Higher efficiency and longer flight time .

Featuring indestructible aviation-grade 7075 aluminum caps with hard anodizing for added durability, these motor components are resistant to scratching or damage without leaving any visible marks. The motors also utilize high-quality NMB bearings with TU1 grade enamel-coated wire, along with a high full-slot ratio and low internal resistance for improved performance.

The motor’s eddy current hysteresis loss is minimized, resulting in improved efficiency. The motor features a length of 250mm, with specifications including: 45.7g/cm density, 3.5% magnetic saturation, 47A/cm magnetic field strength, and 19.5T coercivity. Additionally, the motor’s bearings are 4-M3 grade Hoppen bearings, which can withstand greater axial loads.

Special Edition V4 motor specifications:- KV rating: 580KV, 950KV, or 1050KV (configurable)- Configuration: 12N14P- Maximum thrust: [not specified]- Motor weight: 91.70g- ESC options:+ 6S, 45A continuous current+ 6S, 65A burst current+ 4S, 80A burst current- Recommended battery configuration: 6 cells (Lipo)- Motor dimensions (mm): 38.2 x 45.7- Propellers: GF 13x8x3 Glass Fiber Nylon

Special Edition V4 32512 580KV-6S-GF13x8x3 Test Report Muk” The test base on 2022 BrotherHobby Remark bench for reference only.

Testing Note: Based on BrotherHobby’s Remark bench test (2022), this motor specification serves as a reference only.**Motor Performance at 950KV*** ESC: 6S HQ103, with a maximum power output of 1590.68W* Propeller: HQ10x5x3 Glass Fiber Nylon, with a maximum current draw of 64.40A* Insulation Resistance: P0.5MQ (pass requirement)* Dynamic Balance: 3mg Coil Test PASSNote: The above specifications meet the relevant standards for testing.

Testing Note: This specification is based on BrotherHobby’s Remark bench test (2022) and serves as a reference only.**Temperature Testing*** The temperature reading was taken from the copper wire inside the motor, with a minimum operating temperature of 100C (ZMIN) when running at throttle.